Denso 234-4169 Oxygen Sensor

Comments

1. Z. PENA "ZMAN" says

   March 13, 2015 at 1:46 pm
   11 of 12 people found the following review helpful

   
   Denso 234-4169 Oxygen Sensor, December 8, 2009

   By 

   Z. PENA “ZMAN” (ZMAN) –
   
     

   Verified Purchase(What’s this?)

   This review is from: Denso 234-4169 Oxygen Sensor (Automotive)

   I have a toyota 03, This product arrived within 2 days of purchase. It’s was the right product. It fit prefect!If you want to make your job easier purchase oxygen sensor socket for about $3 at harbor freight…Another thing, I know it doesn’t show it but it does have the factory plug on it as well and matches up perfectly.I would recommended it…

   0

   Help other customers find the most helpful reviews 

   Was this review helpful to you? 
   

   
   |

    Comment

   Reply
2. John says

   March 13, 2015 at 1:46 pm
   3 of 3 people found the following review helpful

   
   2000 Toyota Tundra, 4WD, SR5, 4.7 L, February 16, 2011

   By 

   John –

   Verified Purchase(What’s this?)

   This review is from: Denso 234-4169 Oxygen Sensor (Automotive)

   O2 Sensor fit perfect. Came with a small package of quality anti-seize. Easy to replace for a shade tree mechanic except the electrical plug is nearly impossible to unplug – can only get one hand in area of plug – but with patience it can be done by a shade tree mechanic. You will need an OBII Scanner to erase the fault code or have Advance Auto erase it for you.

   This sensor fits both passenger and driver side O2 sensors on upstream side of catalytic converter. This will cure your PO135 and PO155 error codes (of course it could also be a wiring problem, but if you have 60,000 miles on the OD, it is most likely the O2 Sensor. My first one failed at 83,000 miles. Both the upstream and one downstream O2 sensors have failed. One downstream is still working and I have 220,000 miles on the OD. O2 sensors are rated for about 100,000 miles. The only other failure on this truck was a $75 ignition coil on the #8 cylinder.

   4 wire Denso “first time fit” oxygen sensor, original equipment direct plug in, no wire cutting. 10.83 in. lead wire.

   Designed with precision, manufactured to the highest O.E. quality, guaranteed to fit right the first time. This O2 sensor will outlast most other oxygen sensors due to Denso’s superior quality. Constructed with Denso’s exclusive aluminum oxide trap, this extra layer helps to protect from silicone and lead poisoning which causes premature sensor failure. This combined with other Denso high quality features including stainless steel housing and porous teflon filter all contribute to make a long life oxygen sensor with improved engine performance and greater fuel efficiency.

   June 1, 2014
   The three O2 sensors I replaced in Feb of 2011 are still working fine.

   0

   Help other customers find the most helpful reviews 

   Was this review helpful to you? 
   

   
   |

    Comment (1)

   Reply